mold work for occupied buildings

Commercial Mold Removal That Follows Texas Rules From Day One

Last updated November 2026

CRS performs commercial mold removal for San Antonio offices, retail centers, clinics, schools and multi-family properties under Texas TDLR rules and IICRC S520. On remediation projects we work from a protocol written by an independent licensed Mold Assessment Consultant, as Texas law requires, and we contain the work with negative air and HEPA filtration so tenants keep working. The job ends with the assessor’s clearance and our Certificate of Mold Damage Remediation.

Tom Lott, a San Antonio native who has run CRS with his wife Yolanda since 1989, holds two State of Texas mold licenses: Mold Assessor and Mold Remediation Contractor. Texas keeps assessment and remediation separate on any one project, so on a given project we fill one role or the other, never both. Holding both licenses means Tom knows the rules from both sides, which helps when an assessor’s protocol has to become a commercial mold remediation plan a working building can live with.

Commercial mold in a building is almost always a water problem first. Around San Antonio the usual sources are roof leaks over drop ceilings, condensate from rooftop units, plumbing leaks inside walls, and humidity that cooling equipment never pulls out. Removing growth without fixing the source only schedules the next job, so every scope we write names the moisture source and who is fixing it.

Who Writes the Protocol for Commercial Mold Removal in Texas?

A licensed Mold Assessment Consultant who is independent of the company doing the commercial mold remediation. Texas Occupations Code 1958.155 bars one license holder from doing both assessment and remediation on the same project, and bars anyone from owning an interest in both companies on it. The remediator then works from a plan that follows that protocol.

The TDLR mold FAQ says the same, and TDLR’s enforcement list treats owning an interest in an entity that does both on one project as a sanctionable violation. The one exception TDLR lists is a school district employee working on that district’s own project. In practice the rule works in your favor: the person who decides how much mold there is, and later whether it is gone, has no stake in the size of the removal bill. Commercial mold removal under an independent protocol is what Texas requires on licensed projects, and it is the only way we work.

We can assess, or we can remediate, but Texas law keeps those roles separate on any one project, so when we remediate, the consultant is an unrelated company you can choose. Our pages on mold inspection and testing and air quality testing explain what the assessment side of commercial mold work involves.

Texas Mold Law for Commercial Buildings, Rule by Rule

Texas regulates mold work through TDLR under Occupations Code Chapter 1958 and the rules at 16 TAC Chapter 78; the program moved from DSHS to TDLR in 2017. Here is how those rules apply to commercial mold removal in San Antonio, line by line.

RuleWhat Texas requiresWhat it means for your building
Under 25 contiguous square feetAn owner or tenant, or their managing agent or employee, may do mold work on property they own or lease without a license. The exemption does not cover anyone doing mold work for the public as a business.Your own maintenance staff can handle a small spot. Contiguous means close together, and if an antimicrobial is applied, the whole treated area counts.
25 contiguous square feet or moreLicensed professionals only: a licensed remediation contractor working from a licensed assessor’s protocol, with TDLR notified at least 5 days before work starts.Build the notice period into your start date. Licensees follow all of Chapter 78 even on smaller jobs.
One project, two rolesNo license holder may assess and remediate the same project, and no one may own an interest in both companies on it.Your assessor and your remediator are separate, unrelated companies.
ClearanceA licensed Mold Assessment Consultant performs the post-remediation assessment by visual, procedural and analytical methods, while walk-in containment is still up. A consultant who did not write the protocol cannot declare clearance.Containment stays standing until the assessor passes the area, and the assessor checks, as far as feasible, that the underlying cause was fixed.
Certificate (CMDR)TDI Form MDR-1, issued only by the licensed remediator, no later than 10 days after remediation is finished. The assessor completes a separate section.Keep it with the building records: a seller must give buyers copies of every certificate from the previous 5 years.
After a water event16 TAC 78.30 recognizes emergency containment when delaying remediation after water damage would increase mold contamination.Drying and containment can start before the protocol is written.

Two traps catch commercial owners. First, the 25 square foot line counts contiguous growth across the whole project, so patches close together in one suite can add up past it. Second, the certificate’s insurance protection is narrower than many people assume: Texas Insurance Code 544.303, which bars underwriting decisions based on prior remediated mold, applies to residential property policies, so do not count on it for a commercial policy. The certificate still documents that the commercial mold remediation met the protocol, and buyers will ask for it.

Commercial Mold Removal With Tenants Still in the Building

Most commercial buildings cannot empty out for mold work, and most do not have to. IICRC certified commercial mold removal with tenants in place depends on containment: poly walls sealed to the deck, an airlock or zippered entry, and negative air machines with HEPA filters exhausting so air flows into the work area instead of out of it. The HVAC serving that area is isolated, so spores do not ride the return air into the next suite, and we check the pressure difference while the work runs.

Under IICRC S520-2024, the goal is to return affected areas to Condition 1, normal fungal ecology. Condition 3 is actual growth, and Condition 2 is settled spores or fragments that drifted from a Condition 3 area. That is why a commercial mold cleanup covers the dust around the growth as well as the growth: HEPA vacuuming and damp wiping inside containment, removal of porous materials with growth, and cleaning of the structure before clearance. Our article on S520 protocols for property recovery walks through the standard in more depth.

Ceilings deserve their own note. The plenum above a suspended ceiling is often shared across suites and open to the return air, so a stain on one tile can mean growth on the back of many and on the deck above. Commercial mold removal in drop ceilings means lifting tiles inside containment, inspecting the plenum, and bagging damaged tiles there instead of pulling them in an open office. Loud or dusty tear-out moves to nights, while quiet HEPA filtration runs around the clock.

Mold and water damage found during home inspection San Antonio
Moisture meter detecting water damage in San Antonio home

Rooftop Units, Ductwork and the San Antonio Humidity Problem

Humidity is the background to most commercial mold here. Morning relative humidity in San Antonio is in the 80s through much of the year, and the EPA guide for schools and commercial buildings tells owners to clean and dry wet or damp spots within 48 hours. Indoors, trouble often starts with cooling equipment. A short-cycling rooftop unit, usually one sized too large for the space, cools fast and shuts off before the coil runs long enough to pull moisture out, so the thermostat is satisfied while the air stays damp. Over a summer, that air finds the coldest surfaces: supply diffusers, uninsulated duct runs and the ceiling tiles beside them.

That makes commercial mold removal from HVAC ductwork a two-contractor job. The protocol decides which duct sections, liners, coils and drain pans are cleaned and which are replaced, and we keep the system off or isolated while the work runs. Replacement parts and the moisture fix itself, whether that is a drain repair, controls or a properly sized unit, belong to your mechanical contractor. Duct mold cleaned while the unit keeps short-cycling comes back.

Roof leaks are the other common start. Flat and low-slope roofs pond after heavy rain, and San Antonio sits in Flash Flood Alley, where storms drop a lot of water fast. Commercial mold removal after a roof leak goes faster when the water side is handled first: our large-loss drying service dries the deck, insulation and walls so the mold scope stops growing, and Texas rules allow emergency containment after a water event before the protocol is in hand.

Our Commercial Mold Remediation Sequence, Start to Clearance

Texas rules and S520 both depend on doing these steps in order.

1

Independent Assessment

A licensed Mold Assessment Consultant with no ties to CRS inspects, samples as needed and writes the protocol for the commercial mold cleanup. For projects of 25 contiguous square feet or more, TDLR is notified at least five days before work starts.

2

Work Plan and Containment

We turn the protocol into a work plan: containment layout, negative air and HEPA air scrubbers, HVAC isolation, after-hours tear-out, and how tenants get around the work area. You approve the schedule before the first poly wall goes up on the commercial mold remediation.

3

Removal and Cleaning

Commercial mold cleanup bags and removes porous materials with growth inside containment, then HEPA vacuums and damp wipes the structure. Dry ice blasting can clean framing or decking where it fits. We confirm the moisture source is fixed and photograph every step.

4

Clearance and Certificate

The consultant who wrote the protocol performs the post-remediation assessment with containment still up. After it passes, containment comes down, and we issue the Certificate of Mold Damage Remediation within 10 days of finishing the commercial mold removal.

Does a Commercial Policy Cover Commercial Mold Removal?

Sometimes, and usually only in part. Many commercial property policies exclude mold or cap it with a low sublimit, often tied to a covered water loss such as a burst pipe. Mold from long-term humidity or a slow leak is where coverage questions usually start. Check your declarations page and endorsements before commercial mold remediation begins.

Documentation decides how a sublimit gets applied. When mold follows a covered water event, our records separate the water mitigation from the mold work by room, date and line item, so the adjuster can see which dollars belong to which coverage. Our customer relations lead is Yolanda, whose earlier career was at one of America’s largest insurers, and CRS works with all carriers and bills insurance directly. In a leased building the lease usually decides who repairs what, so landlord and tenant should both read it before the commercial mold cleanup scope is signed.

Call Before the Spot Passes 25 Square Feet

Small spots grow, and a patch your maintenance team could legally clean this month can pass 25 contiguous square feet by the next. Under 16 TAC 78.30, an exempt person who finds more mold mid-job that brings the total to 25 or more must stop, use emergency containment if needed, and tell the client. Call when you first see it, and a licensed owner will tell you which side of the line your commercial mold problem is on.

call 210-656-2112
CRS San Antonio restoration team member on site

Commercial Mold Removal Across Stone Oak, Alamo Heights and Bexar County

From our office at 4243 GateCrest, Suite 101, San Antonio, TX 78217, we handle commercial mold remediation in San Antonio, Stone Oak, Alamo Heights, and nearby areas, and a licensed owner answers the phone 24/7. Relatively few companies here hold a Texas mold remediation contractor license, so ask any commercial mold removal contractor for its license before work starts.

In Stone Oak, newer medical and office buildings along US 281 and Loop 1604 run large rooftop systems, where short-cycling and condensate feed commercial mold in ducts and ceilings. In Alamo Heights, older commercial buildings along Broadway bring plaster, older roofs and wall cavities that hold moisture. Out at Alamo Ranch, newer retail and office space off Loop 1604 and Culebra Road puts long runs of drop ceiling under low-slope roofs.

We also serve Bandera Road businesses in Helotes, Northeast Side offices along Walzem Road in Windcrest, newer retail along FM 78 in Cibolo, and commercial buildings in New Braunfels near the Comal and Guadalupe rivers. Searching commercial mold removal near me from any of them reaches the same local commercial mold removal company and the same licensed owners.

Our 4.9-star Google rating from 91+ verified reviews and BBB A+ standing put us among the top-rated commercial mold removal companies in San Antonio, and our credentials page lists our IICRC certified firm, EPA certified firm and CERC status. Our expert crews bring the same containment, negative air and HEPA equipment to every mold remediation for businesses, large or small.

What Building Owners Ask Us About Commercial Mold Removal

It depends on size and access. A small contained area may take a few days of work, while ductwork, large ceiling areas or several suites take longer. Add at least five days of TDLR notice on projects of 25 contiguous square feet or more, plus the assessor’s clearance visit. Any commercial mold remediation schedule is an estimate until the protocol is in hand.

Usually only the people whose space is inside the containment. Neighboring suites keep working while negative air holds the work area at lower pressure. Clinics, childcare rooms or occupants with weakened immune systems may need more distance, and the assessor’s protocol for the commercial mold cleanup sets that.

Yes, if it covers less than 25 contiguous square feet and the building is one your company owns or leases. Count the whole area you treat with any antimicrobial. If the spot turns out bigger and the total reaches 25 or more, stop, contain it, and call a licensed company for commercial mold remediation.

Keep the assessor’s protocol, our work plan, photos, the post-remediation assessment report and the Certificate of Mold Damage Remediation, TDI Form MDR-1. If you sell, Texas requires giving the buyer every certificate issued for the property in the previous 5 years, so file them with the building records for any commercial mold work.

No. Paint and bleach can hide growth on porous drywall without removing it, and standard S520 practice removes porous materials that have growth. On a licensed project, the commercial mold remediation has to follow the assessor’s protocol, and the assessor checks the result at clearance.

Yes. SB 1255 took effect September 1, 2025. It repealed the exemption that let a license holder’s supervised employees do mold work without their own license, removed mycotoxins from the statutory definition of mold, and took post-fire or post-disaster demolition out of regulated activity. TDLR’s current rules stay in effect until it adopts new ones, so ask any commercial mold contractor how its crew is licensed.

Schedule a Mold Site Visit

Book a Commercial Mold Removal Site Visit

Tell us where you see or smell growth. A licensed owner answers 24/7 and can walk you through the Texas steps for commercial mold work before anyone opens a wall.

call 210-656-2112

our team will call back within 5-minutes